The Cirrus DC fan ships with a 6” down rod pre-installed. If ceiling height allows,
using a longer down rod will increase airflow and efficiency. However, the blades
must be at least 7 feet above the floor.
To install a longer down rod, proceed as described here. Otherwise, proceed
to Step 3.
2
5
WARNING
See Page 2
POWER OFF
Circuit Breaker
(a) Remove stopper pin and half ball from small
down rod by loosening set screw on half ball. Set
these parts and canopy aside for reinstallation.
(b) Remove top dome by loosening screw on fitting
against down rod, above top dome. Slide fitting and
dome up down rod and set aside for reinstallation.
(c) Slightly loosen three
set screws where down
rod is attached to motor
and remove the cotter pin
and through pin assembly.
Set all parts aside for
reinstallation.
(d) Remove down rod and run fan wires through selected replacement down
rod. In reverse order, follow steps above to reassemble. Canopy can rest on top
dome until wiring connections are made.
Note:
When tightening the three screws where the down rod attaches to
the motor, take care that the down rod is centered evenly. This may require
adjustment of the three screws.
Very Important:
The through pin and cotter pin assembly at the base of the
down rod, and the stopper pin at the top of the down rod, must be reinstalled
for a safe and secure installation of your fan.
stopper pin
fitting
top dome
set screw
canopy
