The Handy THPK27L, Owner'S Manual

Page: 8 / 28

7-5. Lead wire
Connect the 2 lead wires from the throttle trigger to the corresponding 2 wires from the engine as in Fig.6.
Fig.6 Fig.7
7-6. Wearing the double-shoulder harness
Pass your arms through the straps as if putting on a coat. Buckle the harness at the front of your body.
Set the shoulder pads properly. Fig. 7
CAUTION
Only use the quick release mechanism in an emergency!
The double-shoulder harness has a quick release mechanism so that you can release the harness instantly
in an emergency.
1. Pull the harness grip upward to separate the hook from the harness so that the harness is separated from the trimmer.
2. To reconnect the harness to the trimmer, readjust the grip by pulling it and reset the hook ring as in Fig.8-2.
Fig. 8-1 Fig. 8-2 Fig. 8-3
7-7. Cutting attachment mounting.
For the nylon line cutting attachment
1. Match the hole in the side of the cutting attachment guard with the hole in the side of the gear housing.
2. Then insert a 4mm Allen wrench into the holes to stop the clamp moving. Fig. 10
3. Undo the shaft nut by turning in a clockwise direction with the spanner provided.
4. Insert the upper clamp and lower clamp into the gear housing.
5. Rotate the nylon cutting head counterclockwise by hand to attach it to the gear housing.
6. Remove the Allen wrench.
Fig. 9 Fig. 10
7