EN - 10368 - Electric drill, grinder, polisher set
The HANDY DRILL sanding, engraving and drilling machine has been
specially developed for home, manicure / pedicure and DIY purposes. You
can use it to drill small holes, polish, engrave or even cut. It can be ideal
for removing burred edges. Maximum shaft diameter Ø3.2 mm. The various
chucks can be connected easily and quickly. Thanks to its compact size and
weight, the tool is easy to handle, even in hard-to-reach places. It can also be
suitable for precise machining of wood, metal and plastic.
Use
Hold the device as if you were holding a writing instrument. Be careful
not to press the chuck lock button (B) during operation , as this may
damage the device.
The switch (C) on the end of the appliance can be used to switch the
appliance on and off. Before connecting to the mains, make sure that the
power button is in the “0” position. To avoid dangerous situations, only
connect the device to a power source when it is set this way!
(A)
(E)
(C)
(B)
(D)
Change of accessories
1. Turn off the device and make sure it is completely stopped. (For the
higher security and to avoid the injuries remove the power cable from
the wall socket!)
2. Push and hold the collet lock (B) button and turn the collet until the
button descends!
3. When the collet has locked, turn the collet closing cap (A) and remove
the accessory/head.
4. Place the new accessory or head onto the collet and screw the closing cap to
close, while the LOCK BUTTON is held all time.
5. Release the LOCK BUTTON!
Accessories
A - Chuck cap
B - Chuck lock button
C - On / Off switch
D - Clamping head (chuck)
E - Clamping heads
