3.
Secure the Vanity
With assistance, lift and slide the vanity over the brackets.
Ensure the back of the vanity is flush against the finished wall with the brackets
properly seated inside the vanity.
WARNING: Risk of property damage.
It is required that wood screws be
installed through the hanger and into the vanity, as shown. This will ensure the
vanity is properly secured.
NOTE: If the vanity is not flush:
If the gap is 1/8
″
(3 mm) or less, insert wood shims
(not provided) behind the vanity. If the gap is greater than 1/8
″
(3 mm), correct the
finished wall until it is plumb.
CAUTION: Risk of property damage.
Secure the vanity with all of the screws
illustrated. This will ensure the vanity is secured properly to the finished wall.
From the inside of the vanity, secure the vanity to the brackets with the washers
and screws provided.
Secure the backside of the vanity to the finished wall with 2-1/4
″
screws (not
provided).
Install the drawers. Refer to the
″
Drawer and Shelf
″
section for proper installation.
NOTICE:
The top of each drawer must sit just below the top of the vanity. If each
drawer is not at the proper height, the top of each drawer will be damaged or will
not open when the lavatory is installed.
Verify the top of each drawer sits just below the top of the vanity. If necessary,
refer to the
″
Drawer and Shelf
″
section to properly adjust the height of each
drawer.
Screws
Vis
Tornillos
Front View
Vue avant
Vista frontal
Screws
Vis
Tornillos
Screws
Vis
Tornillos
Kohler Co.
11
1082756-2-B