Propeller
2 x springs
Battery
compartment
with wires
Plain wood
sheets
Illustrated
wooden
sheet
YOU NEED ...
Motor
1
3
You will also need: 2 x AA batteries
(1.5-volt, type LR6/Mignon)
HERE’S HOW!
1
Slot the two side pieces onto the pins
protruding from either side of the motor casing.
2
Insert a cross panel by sliding it into the slots
on each side wall. Make sure that you keep the
wires from the motor on the top side
of the panel.
3
Insert the two springs into the precut holes,
narrow side down. If you move the springs to
one side with your finger, to make a little gap,
you can insert the wire through the rings.
Connect the black wire to one spring, and the
red wire to the other spring. To finish, from
above, slide another panel downward in front
of the motor.
4
From behind, push the whole structure back
into the wooden piece printed with the
underwater volcano on it.
5
Then place the whole thing onto the base of the
ship. At the front of the ship, you’ll see an axle
protruding from the motor block. This is where
you attach your propeller.
2
28
Ship’s Propeller
and the
