Tub
Cardboard
sheet
YOU NEED ...
3 x plain
wooden sheets
10-cm
string
3 x 2-piece
screws
1 x 30-cm tube,
1 x 20-cm tube
HERE’S HOW!
1
Use one of the screws to attach the base of the
crane to the precut opening in the base panel
of the ship. The screw is made up of two pieces
that can be separated by turning them
counterclockwise and then screwed into each
other by turning them clockwise. Take one of
the screw pieces, and from above, insert it
down through the middle hole in the crane
base, and then down through the base panel of
the ship. From beneath, twist the other screw
piece up into the screw piece above. Tighten
the screw firmly using a flat-head screwdriver
if necessary.
Warning: Make sure that the
longer slots in the crane base point toward
the front of the ship.
2
Now, with their tabs pointing downward, insert
the two sides of the crane into the crane base.
The crane side with the hook on its lower end
must be inserted into the left-hand slot.
3
With the remaining two screws, attach the
crane jib pieces to the inner sides of the crane.
Use a flat-head screwdriver if necessary.
4 x syringes
You will also need: ruler, scissors, adhesive tape,
tap water, large flat-head screwdriver
2
3
1
Crane side with hook
Long slot
19
Ship’s Crane
and the
