TGB Blade 525, Service Manual

Page: 84 / 209

To this chapter contents
6. CYLINDER HEAD/VALVE
After the valve seat ground, coat valve seat
surface with emery and then slightly press the
ground surface.
Clean up all emery coated onto cylinder and valve
after ground.
Cylinder Head Reassembly
Lubricate
valve stem with engine oil, and then insert the
valve into valve guide.
Install new valve stem oil seal.
Install valve springs and retainers.
Caution
The closed coils of valve spring should face down
to combustion chamber.
Use a valve cotter remove & assembly tool to
press the valve spring, and then remove valves.
Caution
In order to avoid damaging the valve stem and the
cylinder head, in the combustion chamber place a
rag between the valve spring remover/installer as
compressing the valve spring directly.
Special Service Tool:
Valve cotter remove & assembly tool
Tap the valve stems gently with a plastic hammer
to make sure valve retainer and valve cotter is
settled.
Caution
Place and hold cylinder head on to working table
so that can prevent from valve damaged.
6-13
Valve cotter remove
anassembly tool
PDF created with pdfFactory Pro trial version www.pdffactory.com