
To this chapter contents
1. GENERAL INFORMATION
●
Do not let the wire harness contact with rotating,
moving or vibrating components as routing the
harness.
●
Keep wire harnesses far away from the hot
parts.
Never Touch
●
Route wire harnesses to avoid sharp edges or
corners and also avoid the projected ends of
bolts and screws.
●
Route harnesses so that they neither pull too
tight nor have excessive slack.
●
Protect wires or wire harnesses with electrical
tape or tube if they contact a sharp edge or
corner. Thoroughly clean the surface where
tape is to be applied.
●
Secure the rubber boot firmly as applying it on
wire harness.
●
Never use wires or harnesses which insulation
has been broken. Wrap electrical tape around
the damaged parts or replace them.
●
Never clamp or squeeze the wire harness as
installing other components.
Never clamp or
squeeze the wire
harness
Never too tight
1-7
PDF created with pdfFactory Pro trial version
www.pdffactory.com
Summary of Contents for Blade 525
