31
30
MEMO
- Wireless weather station
MEMO
- Wireless weather station
7.3 Weather forecast
Sunny
Slightly cloudy
Cloudy
Rainy
Stormy
• The weather station has five different weather symbols (sunny, slightly cloudy, cloudy, rainy, stormy).
• The weather forecast covers a range of 12 hours and indicates only a general weather trend. For
example, if the current weather is cloudy and the rain symbol is displayed, it does not mean the
product is faulty because it is not raining. It simply means that the air pressure has dropped and the
weather is expected to get worse but not necessarily rainy. The accuracy is about 70 %.
• The sun symbol also appears on a starry night.
Note!
• Please note that the forecast symbol will become more defined in the course of operation. The fore-
cast symbol is active right from the start, however, the reliability of the forecasts increases with the
amount of data collected.
7.4 Temperature and humidity
7.4.1 Maximum and minimum values
• The highest and lowest indoor and outdoor temperature and humidity since the last reset are perma-
nently displayed.
• The maximum and minimum values are automatically reset at midnight.
• Press and hold the
CLR/SNZ
button for 2 seconds to reset the values manually.
7.1.4 Time zone setting
• In the setting mode you can make the time zone correction (+12/-12).
• The time zone correction is needed for countries where the DCF signal can be received but the time
zone is different from the DCF time (e.g. +1=one hour plus).
7.2 Alarm function
• Press the
MODE
button in normal mode, to enter the alarm mode.
• ALARM and 07:00 (default) or the last adjusted alarm time appear on the display.
• Press and hold the
MODE
button.
• The alarm symbol will appear and the hour digit will be flashing. The alarm is activated.
• Press the
+/°C °F
or
-/RCC
button to adjust the hours.
• Confirm the setting with the
MODE
button and set the minutes in the same way.
• Press the
MODE
button again.
• The current time and the alarm symbol appear on the display.
• When the adjusted alarm time is reached, the alarm will ring.
• The alarm symbol will be flashing.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two min-
utes and will be reactivated at the same set time.
• Press any button (except
CLR/SNZ
) and the alarm will stop.
• Press
CLR/SNZ
button to activate the snooze function.
• Once the snooze function is activated, Zz will be flashing on the display.
• The alarm will be interrupted for 10 minutes.
7.2.1 Activate/turn off alarm
• Press the
+/°C °F
or
-/RCC
button in alarm mode to activate or deactivate the alarm function.
• The alarm symbol appears/disappears.
TFA_No. 35.1141_Anleitung_04_20 24.04.2020 9:35 Uhr Seite 16
