43
automatically toggled to display. However, if the probe is unplugged, the transmitter' s
display will only show the reading from the inner transmitter.
Once the transmitter is successfully recognized by the temperature station, Channel 1 of
the Temperature station will display the temperature data measured by internal sensor and
Channel 2 will display the temperature estimated by the probe.
If the measuring probe is unplugged, the "probe channel" on Temperature station will show
"---", yet the data from the internal transmitter will still be shown on Channel 1 .
The probe can be connected to the remote temperature transmitter anytime after initial
setup. There is no need to reset the units, should the probe be unplugged or re-plugged
again. The Temperature Station will automatically detect the temperature probe data and
will display the temperature data on Channel 2 after the probe is plugged.
SETTING UP:
When one transmitter is used:
1.
First, insert the batteries into the transmitter (see “
Install and replace batteries in
the Temperature transmitter
” below).
2.
Within 30 seconds of powering up the transmitter, insert the batteries to the
Temperature Station (see “
Install and replace batteries in the Temperature
Station
” below). Once the batteries are in place, all segments of the LCD will light up
briefly. Then the indoor temperature and the time as 0:00 will be displayed. If they are
not shown on LCD after 60 seconds, remove the batteries and wait for at least 60
