Textron Kubota V2403-CR-TE4, Safety, Operation And Maintenance Manual

Page: 26 / 116

en-26
5 CONTROLS
0.0 Hours
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should read
the entire operators manual before attempting
to set up, operate, adjust or service the
machine.
5.2.Y.1 VISUAL DISPLAY ________________________________________________
The visual display is activated when the ignition is turned on.
5.2.Y.2 STARTUP SCREEN ______________________________________________
When the ignition key is turned to the start position, this screen is shown.
The hour meter will show total hours of engine operation.
5.2.Y.3 WARNING/SERVICE SCREEN _____________________________________
After the startup screen the warning screen is shown, the screen is visible for
Four seconds. If the machine is within 5 hours of the next service, a warning is shown.
An operator input is needed to continue to the main screen. If there is no input needed,
the main screen will become visible. If a fault condition has occurred during the previous
start
, a pop up screen will become visible over the top of the warning screen. The
operator must confirm the fault before they can move to the main screen.
5.2.Y.4 FIRST SCREEN _________________________________________________
This screen shows the cutter switch in the OFF position, the transport lock engaged, the
TST is in operation and Speed mode or Transmission mode is set.
By pressing
the MODE button the transmission mode can be changed between
Automatic, Manual and Creep.
Note. The TST (Tilt Safety Technology) is an active safety device to stop the machine
being used in dangerous conditions.
5.2.Y.5 ENGINE START _________________________________________________
When the ignition key is turned to the start position, this screen is shown.
If the parking brake is applied, the cutting unit switch is in the OFF position and the foot
pedal is in the Neutral position. When the operator is in the seat, the engine will start.
This screen shows the fuel bar graph on the left side. The colour changes from green to
orange and then to red. as the fuel level decreases. The engine temperature gauge is
on the right side. The colour changes from green to orange and then to red. as the
temperature increases.
MODE
TST
™
MODE