Textron Jacobsen SLF530, Repair Manual

Page: 336 / 352

9-12 673831-Rev A
ACCESSORIES AND MISCELLANEOUS REPAIR
9
Chassis
Removal and Installation
See Figures 9-14 through 9-19.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Remove the cutting units. (See “Cutting Unit” on
page
8 -22.)
3. Remove the front and rear lift arms. (See “Lift Arms”
on page
8 -23.)
4. Remove the spring arms. (See “Spring Arms” on
page
8 -23.)
5. Remove the operator platform. (See “Operator
Platform” on page 9-10.)
6. Remove the ROPS. (See “ROPS” on page 9-4.)
7. Remove the hood. (See “Hood” on page 9-4.)
8 . Remove the fuel tank. (See “Fuel Tank” on page 9-5.)
9. Remove the hydraulic oil tank. (See “Hydraulic Oil
Tank” on page 6-62.)
10. Remove the radiator/hydraulic oil cooler. (See
“Radiator/Hydraulic Oil Cooler Assembly” on
page 3-
8 .)
11. Remove the engine assembly. (See “Engine” on
page 3-13.)
12. Support the chassis assembly using jack stands so
the wheels are off the ground.
13. Remove the front wheels. (See “Front Wheels” on
page 9-11.)
14. Remove the rear wheel(s). (See “Rear Wheels” on
page 9-11.)
15. Remove the rear yoke/axle. (See “3WD Option Rear
Yoke” on page 7-25.) or (See “4WD Option Rear
Axle” on page 7-26.)
16. Remove the lift valve. (See “Lift Valve” on page 6-53.)
17. Remove the front and rear reel valve. (See “Reel
Valves” on page 6-55.)
1 8 . Remove the charge filter (See “Charge Pressure
Filter” on page 6-5 8 .).
19. Note how hydraulic hoses and tube are routed
through the mower. Note locations of clamps.
20. Using the Parts Manual as a guide, remove the
hydraulic hoses and tubes from the mower.
21. Remove the front wheel motors. (See “Front Wheel
Motor” on page 5-47.)
22. Remove the 4WD valve. (See “4WD Valve” on
page 5-45.)
23. Note how the wire harness is routed through the
mower. Remove the wire harness.
24. Remove the battery. (See “Battery” on page 4-63.)
Figure 9-14
25. Remove two screws (1), four washers (2), two nuts
(3) and left fender (4).
26. Remove three screws (1), five washers (2), two nuts
(3) and right fender (5).
Figure 9-15
27. Support the front axle (6) using a suitable lifting
device.
2 8 . Remove four nuts (7), eight flat washers ( 8 ) and four
screws (9).
29. Remove four screws (11) and washers (10).
30. Move the front axle away from the chassis.
MAR0360
1
1
1
1
2
2
2
2
2
2
2
2
2
3
3
3
4
5
6
7
8
8
8
9
10
7
8
9
10
11
11
MAR0361