Customer Care
25105 Throttle Sensor Error
Caused by: The throttle position sensor is out of operational range.
3.
Place pos. meter probe A on the
yellow wire
of the accel position sensor
.
Place neg. meter probe B on the black wire
at the pedal position sensor. Leave harness
connected to the sensor. Voltage value should
be between 0.3
8
V and 0.
56
V. If good, go to
step 4. If bad, verify harness.
4.
Leave meter probes in place.
Slowly
d
epress the pedal to the floor. Voltage
should
steadily increase from .5v to
between
4.5V and 4.8V.
Above 4.8v is a fault.
If good,
go to step 4. If bad, replace sensor.
1.
Verify the pedal stop bumper is in
the correct position. If not, correct and
secure in place.
5.
Try a known good controller if error is gone, warranty controller.
Error remains, reinstall controller and contact Customer Care.
2.
Plug all connectors back in. Place
pos. meter probe A on the orange wire
at the #3 position on the controller
plug. Place neg. probe B on the black
wire at the #4 position on the controller
plug. 5V should be observed. If bad,
check all 5V components first, then
try a
known good
controller. If good, go to
step 3.
A
A
B
B
Pedal stop bumper
Page
31
