157 Jaffa Street, "Amot Building" Haifa Israel ,35251 Fax + (972) 4 6228513 . Tel + (972) 4 8216942
5. Check if there are metallic or other obstructions
between the SCC and the gateway; try to activate the
SCC by passing the magnet
6. Bring the SCC closer to the gateway; try to activate
the SCC by passing the magnet
7. The SCC internal energy storage might be depleted –
check latest record of the SCC energy storage voltage
level (in Sol Chip’s portal). If depleted, disconnect the
sensor and connect the SCC charger instead; charge
the SCC for 6 hours. Disconnect the SCC charger and
connect the sensor again. try to activate the SCC by
passing the magnet
8. If none of the above solves the problem, contact Sol
Chip support
Manually forcing a transmission of the SCC:
If you want to get immediate reaction from the sensor, use the magnet to activate
the SCC as follows:
1. Bring the magnet close to the SCC at this point
2. “RF B” (Green) LED at the Wireless Gateway’s panel will blink once
3. You will see transmission at the web site within few seconds
Attention!
Please familiarize yourself with the important safety related notes below:
1. Carefully unpack the Demo kit. When unpacking, care should be taken to prevent dropping
2. One should be very careful while handling the SCC output ports. The sensor connector pins are
connected to the output of the internal energy storage and have a potential of ~3.3V. Shortening the
ports may discharge the internal rechargeable battery very quickly, while damaging the internal
circuitry
3. While the Wireless Gateway is operational, one should note that in order to avoid permanent
damage, neither cellular devices, nor SCC tags should be brought near the gateway’s immediate
surroundings (less than 20 centimeters)
4. The Wireless Gateway has limited lighting protection and it is the user’s responsibility to install
surge protection on the antenna and lighting protection near the gateway unit
5. The SCC-S433 contains a rechargeable battery. Whenever this unit is transported, the carrier’s
shipping constrains should be followed
6.
Do not open any of the kit components. Any damage created due to opening the components is not
under Sol Chip’s responsibility
Support
