Texi XYZ 2517, User Manual

Page: 41 / 47

37
7. Operating
7.1. Preparation

Before starting, ensure there is nobody on the working area.
 Be sure to finish the platform before starting, ensure no sundry in the X/Y chain during the process.

Check whether there is lubricating oil in Y guide.

Check whether the air pressure reaches 0.6Mpa.

Check whether it is correct with tools and installation.
7.2. Operating

Power on.

The machine starts re-set. Re-setting procedures: Cutting head height re-setting, X/Y direction re-setting, cutting head
rotation re-setting, cutting head move to the original place.

In order to avoid cutting the felt, please adjust the depth of tools.
 Put the materials on the table, start the vacuum pump, which make the materials adsorping on the table. If with the
breathable materials, need to put the plastic on it.

Open “Digital cutting system”, import the files (DXF or PLT). The system will process the analysis of outline, definition
the cutting tool and definition the cutting type.
 Start the vacuum pump, move the cutting head, select laser point in CutterServer, review the cutting area. If the
material is not in the reviewing area or exceed, please adjust the material.

Click cutting icon after confirming, the machine will start to cut.

After finishing cutting, please power off and other relevant switch
7.3. Maintenance
7.3.1 Daily Maintenance

Check all the sockets of power, as well as the connector of serial cable.

Before cutting, make X/Y running with slower, then check whether has abnormal sound.