33
6.1.3. V-Cut tool
Picture 19
Picture 20
First blade fitting ramps of the V-cut holder, then put the kidney-shaped slot into the round positioning pins.(picture
19)
V-cut tableting squeeze blade, screw two M4*8 bolt (picture 20),blade installation is complete.(note:If the cylindrical
pin don’t get stuck blade, it will lead to blade breakage and scarp)
Picture 21
Picture 22
Put the V-CUT into the cutting holder (picture 21&22). (Note: the v-cut red point corresponds to the cutting holder’s red
dot, otherwise it will cause installation error.
Summary of Contents for XYZ 2517
