Texi Smart S+B, Instruction Manual

Page: 11 / 16

TEXI SMART S+B 11
13. EMPTYING OF WATER FROM BOILER
After a certain number of hours the machine will signal
the need to empty the water from the boiler. The warning
will be visible only during the first minute the machine is
switched on.
“EMPTY WATER FROM BOILER” will be
displayed. After one minute the warning will disappear,
no matter whether the water has been emptied or not.
This procedure is very important and should be done
regularly in order to eliminate limestone residue, which
may damage the machine.
In order to empty the water, unscrew the water discharge
screw plug. Empty the water into a proper container.
Once the water has been emptied re-assemble the
screw plug, paying attention not to tighten it too much
and checking that there are no water leakages (in this case change the gasket of the screw plug).
WARNING: EMPTY WATER ONLY WHEN THE BOILER IS COLD AND THE ELECTRIC
PLUG IS DISCONNECTED FROM THE MAINS.
14. COMPULSORY PERIODICAL MAINTENANCE
(
TO BE CARRIED OUT EXCLUSIVELY BY AUTHORIZED SERVICE CENTERS, QUALIFIED
TECHNICIANS OR BY THE MANUFACTURER .)
Compulsory maintenance is signaled by the icon .
GENERAL MAINTENANCE
will be
displayed. Contact only your reseller, Authorized Service Centers or the manufacturer in order to
carry out the necessary maintenance. Once the check has been completed, the authorized
personnel will reset the “general maintenance” icon which is shown on the display.
It is also compulsory to change the electric-steam hose or electric cable, if damaged.
15. GOOD FUNCTIONING
Once ironing is finished, leave Texi Smart S+B switched on for 10 minutes. Cool off the ironing board
by activating the vacuum function before switching off the machine. This procedure eliminates water
stagnation and assures long lasting performances.