Texas Instruments UCC2 5 EVM-286 Series, User Manual

Page: 6 / 20

5.3.3 Two-Channel Function Generator Settings
Table 5-1. Two-Channel Function Generator Settings
MODE FREQUENCY DUTY DELAY HIGH LOW
OUTPUT
IMPEDANCE
Channel A
Pulse DC ~ 5 MHz 50%
0 ns
3.3 V 0 V High Z
Channel B 100 ns
5.3.4 Oscilloscope Setting
Table 5-2. Oscilloscope Settings
BANDWIDTH COUPLING TERMINATION SCALE SETTINGS INVERTING
Channel A
500 MHz or above DC 1 MΩ or automatic 10× or automatic OFF
Channel B
5.3.5 Jumper (Shunt) Settings
There are two jumpers (shunts) need to be installed before test:
1. Install shunt #1 for header J3-DIS on pin EN/DIS-GND for the UCC21520EVM shown in Figure 5-1 . For the
UCC20520EVM, UCC21521CEVM and the UCC21530EVM, refer to Table 3-1 . The UCC20520EVM is set
as disable high on the DIS pin while the UCC21521CEM and UCC21530EVM is set as enable high on the
EN pin.
2. Install shunt #2 on header J4-DT on pin VCCI-DT as shown in Figure 5-1 .
Figure 5-1. Jumpers Installation Position
Test Summary www.ti.com
6 Using the UCC21520EVM-286, UCC20520EVM-286, UCC21521CEVM-286,
and UCC21530EVM-286 SLUUBG8C – NOVEMBER 2018 – REVISED OCTOBER 2021
Submit Document Feedback
Copyright © 2021 Texas Instruments Incorporated