EMIF Registers
837
SPNU563A – March 2018
Copyright © 2018, Texas Instruments Incorporated
External Memory Interface (EMIF)
21.3.10 EMIF Interrupt Mask Set Register (INTMSKSET)
The EMIF interrupt mask set register (INTMSKSET) is used to enable the Asynchronous Timeout
Interrupt. If read as 1, the AT_MASKED bit in the EMIF interrupt masked register (INTMSK) will be set and
an interrupt will be generated when an Asynchronous Timeout occurs. If read as 0, the AT_MASKED bit
will always read 0 and no interrupt will be generated when an Asynchronous Timeout occurs. Writing a 1
to the AT_MASK_SET bit enables the Asynchronous Timeout Interrupt. The EMIF on some devices does
not have the EMIF_nWAIT pin; therefore, these registers and fields are reserved on those devices. The
INTMSKSET is shown in
and described in
Figure 21-24. EMIF Interrupt Mask Set Register (INTMSKSET) [offset = 48h]
31
16
Reserved
R-0
15
3
2
1
0
Reserved
WR_MASK_SET
LT_MASK_SET
AT_MASK_SET
R-0
R/W-0
R/W-0
R/W-0
LEGEND: R/W = Read/Write; R = Read only; -
n
= value after reset
Table 21-34. EMIF Interrupt Mask Set Register (INTMSKSET) Field Descriptions
Bit
Field
Value
Description
31-3
Reserved
0
Reserved. The reserved bit location is always read as 0. If writing to this field, always write the
default value of 0.
2
WR_MASK_SET
Wait Rise Mask Set. This bit determines whether or not the wait rise Interrupt is enabled. Writing a
1 to this bit sets this bit, sets the WR_MASK_CLR bit in the EMIF interrupt mask clear register
(INTMSKCLR), and enables the wait rise interrupt. To clear this bit, a 1 must be written to the
WR_MASK_CLR bit in INTMSKCLR.
0
Indicates that the wait rise interrupt is disabled. Writing a 0 has no effect.
1
Indicates that the wait rise interrupt is enabled. Writing a 1 sets this bit and the WR_MASK_CLR bit
in the EMIF interrupt mask clear register (INTMSKCLR).
1
LT_MASK_SET
Mask set for LT_MASKED bit in the EMIF interrupt mask register (INTMSK).
0
Indicates that the line trap interrupt is disabled. Writing a 0 has no effect.
1
Indicates that the line trap interrupt is enabled. Writing a 1 sets this bit and the LT_MASK_CLR bit
in the EMIF interrupt mask clear register (INTMSKCLR).
0
AT_MASK_SET
Asynchronous Timeout Mask Set. This bit determines whether or not the Asynchronous Timeout
Interrupt is enabled. Writing a 1 to this bit sets this bit, sets the AT_MASK_CLR bit in the EMIF
interrupt mask clear register (INTMSKCLR), and enables the Asynchronous Timeout Interrupt. To
clear this bit, a 1 must be written to the AT_MASK_CLR bit of the EMIF interrupt mask clear
register (INTMSKCLR).
0
Indicates that the Asynchronous Timeout Interrupt is disabled. Writing a 0 has no effect.
1
Indicates that the Asynchronous Timeout Interrupt is enabled. Writing a 1 sets this bit and the
AT_MASK_CLR bit in the EMIF interrupt mask clear register (INTMSKCLR).
