![background image](http://html1.mh-extra.com/html/texas-instruments/tms320dm36x/tms320dm36x_user-manual_1095293014.webp)
3.4
CMPUDAT
3.5
SETDIV
3.6
CHSEL
Registers
www.ti.com
The comparison A/D Upper data (CMPUDAT) register is shown in
Figure 5
and described in
Table 5
.
Figure 5. Comparison A/D Upper Data (CMPUDAT) Register
31
10
9
0
Reserved
CMPUDAT
R-0
R/W-0
LEGEND: R/W = Read/Write; R = Read only; -
n
= value after reset
Table 5. Comparison A/D Upper Data (CMPUDAT) Field Descriptions
Bit
Field
Value
Description
31-10
Reserved
0
Any writes to these bit(s) must always have a value of 0.
9-0
CMPUDAT
Comparativer data (upper) value of CMPUDAT should be the same as or larger than that of
CMPLDAT.
The SETUP divide value for start A/D conversion (SETDIV) register is shown in
Figure 6
and described in
Table 6
.
A/D conversion time is obtained by Analog switch setup time + ADC setup time + A/D conversion time.
Analog switch setup time = Peripheral CLK period * (SET_DIV[5:0] + 3)*2
ADC setup time = Peripheral CLK period * (SET_DIV[15:0] + 1)*2
A/D conversion time = Peripheral CLK period* (SET_DIV[5:0] + 1)*24.
Note: A/D conversion time can't be less than 6us.
Figure 6. Setup Divide Value for Start A/D (SETDIV) Register
31
16
Reserved
R-0
15
0
SETDIV
R/W-0xFFFF
LEGEND: R/W = Read/Write; R = Read only; -
n
= value after reset
Table 6. Setup Divide Value for Start A/D (SETDIV) Field Descriptions
Bit
Field
Value
Description
31-16
Reserved
0
Any writes to these bit(s) must always have a value of 0.
15-0
SETDIV
SETDIV bits set the Analog switch setup time, ADC setup (Idle) time and A/D conversion time.
Analog switch setup time = Peripheral CLK period * (SET_DIV[5:0] + 3)*2
ADC setup time = Peripheral CLK period * (SET_DIV[15:0] + 1)*2
A/D conversion time = Peripheral CLK period* (SET_DIV[5:0] + 1)*24.
The analog Input channel select (CHSEL) register is shown in
Figure 7
and described in
Table 8
. CHSEL
setting for the selection of different channel is shown in
Table 7
. In order to select two or more channels,
ORing of these setting is needed.
14
Analog to Digital Converter (ADC) Interface
SPRUFI7 – March 2009
Submit Documentation Feedback