![background image](http://html1.mh-extra.com/html/texas-instruments/ths4082/ths4082_user-manual_1094191015.webp)
Using the THS4082 EVM in the Inverting Mode
1-9
General
1.6
Using the THS4082 EVM in the Inverting Mode
The THS4082 EVM operates from power-supply voltages ranging from
±
5 V
to
±
15 V. As shipped, the EVM is configured for noninverting operation. Move
the resistors as detailed above to configure the EVM for noninverting
operation, which sets the gain to –1. Signal inputs on the module are
terminated for 50-
Ω
nominal source impedance. An oscilloscope is typically
used to view and analyze the EVM output signal.
1) Ensure that all power supplies are set to OFF before making power supply
connections to the THS4082 EVM.
2) Connect the power supply ground to the module terminal block (J2)
location marked GND.
3) Select the operating voltage for the EVM and connect appropriate split
power supplies to the module terminal block (J2) locations marked –VCC
and +VCC.
4) Connect an oscilloscope to the module SMA output connector
(J3/J5)
through a 50-
Ω
nominal impedance cable (an oscilloscope having a 50-
Ω
input termination is preferred for examining very high frequency signals).
5) Set the power supply to ON.
6) Connect the signal input to the module SMA input connector
(J1/J2).
Note:
Each EVM input connector is terminated with an equivalent 50-
Ω
impedance
to ground. With a 50-
Ω
source impedance, the voltage seen by the THS4082
amplifier IC on the module will be
the source signal voltage applied to the
EVM. This is due to the voltage division between the source impedance and
the EVM input terminating resistors (R1 || R4 and R9 || R12).
7) Verify the output signal on the oscilloscope.
Note:
The signal shown on an oscilloscope with a 50-
Ω
input impedance will be 1/2
the actual THS4082 amplifier IC output voltage. This is due to the voltage
division between the output resistor (R7, R15) and the oscilloscope input im-
pedance.
Summary of Contents for THS4082
