Texas Instruments LMK04208, User Manual

Page: 8 / 36

Default TICS Pro Modes for the LMK04208
www.ti.com
8 SNAU200 – September 2016
Submit Documentation Feedback
Copyright © 2016, Texas Instruments Incorporated
LMK04208 User’s Guide
5 Default TICS Pro Modes for the LMK04208
TICS Pro saves the state of the selected LMK04208 device when exiting the software. To ensure a
common starting point, the following modes listed in
Table 4 may be restored by clicking “Mode” and
selecting the appropriate device configuration.
Table 4. Default TICS Pro Modes for the LMK04208
Default TICS Pro Mode Device Mode CLKin Frequency OSCin Frequency
CLKin1 122.88 MHz, OSCin
122.88 MHz
Dual PLL, Internal VCO 122.88 MHz 122.88 MHz
CLKin0 122.88 MHz, Dual
Loop 0-delay, 122.88 MHz
VCXO
Dual PLL 0-delay, Internal
VCO
122.88 MHz 122.88 MHz
Figure 3. Selecting a Default Mode for the LMK04208 Device
6 Using TICS Pro to Program the LMK04208
This section will demonstrate how to use TICS Pro. Making measurements with the LMK04208 device will
serve as an example. For more information on using TICS Pro, refer to
Appendix A and TICS Pro
instructions, "Help" → "TICS Pro User Manual."
Before proceeding, be sure to follow the instructions in Section 3 to ensure proper connections.
6.1 Start TICS Pro Application
Click “Start” → “Programs” → “Texas Instruments” → “TICS Pro” → “TICS Pro”
The TICS Pro program is installed by default to the TICS Pro application group.
6.2 Select Device
Click “Select Device" → "Clock Generator/Jitter Cleaner (Dual Loop)" → "LMK04208”
Upon start, TICS Pro will load the last used device. To load a different device, click “Select Device” from
the menu bar, then select the subgroup and finally, the device to load. For this example, the LMK04208 is
chosen.
6.3 Setup and Confirm Communications
If not already plugged in, connect USB2ANY interface. Click "USB communications" → "Interface"
Ensure USB2ANY is selected in the Communication Setup window. Press the Identify button to confirm
desired USB2ANY is selected by observing blinking LED. Other instances of TICS Pro can be used at the
same time, but if a USB2ANY is used in one application, in cannot be used in the second and may not
show up.