Texas Instruments DS90UB95x-Q1, User Manual

Page: 4 / 54

2 Quick Start Guide
The quick start guide is intended to get the DS90UB95x-Q1EVM operational with the minimum amount of
information. See
Section 3.5 in the troubleshooting section for in-depth, step-by-step instructions.
2.1 System Requirements
The major components of the DS90UB95x-Q1EVM are:
• DS90UB95xSerializer Board
• On-board Power-over-Coax (PoC) interface
• FAKRA connector for digital video, power, and diagnostics
• On-board I2C programming interface
To demonstrate, TI recommends the following (not included):
• DS90UB954-Q1EVM (or variant)
• One DACAR/FAKRA coax cable
• DC power supply for DS90UB954-Q1EVM (or variant) only
• Power supply cables: for example, banana to coax, banana to grabber, and so forth.
• Two male USB-to-mini USB cables
• USB2ANY or an Aardvark I2C/SPI Host Adapter
• Analog LaunchPAD software (download
Analog Launch PAD from TI.com (a myTI Login required). Steps for
installation can be found in Section 3.3 ). This software is not required if an external ECU is used.
2.2 Application Block Diagram
IDx
MIPI CSI-2
HS_GPIO
(SPI)
Image
Signal
Processor
(ISP)
Full HD
Image Sensor
1920x1200
60fps
I2C
1.8 V 1.8 V
MIPI CSI-2
D3+/-
D2+/-
D1+/-
D0+/-
CLK+/-
FPD-Link III
(over Coax or STP)
HS_GPIO
(SPI)
IDx
I2C
DS90UB953
Serializer
0.033 µF 0.033 µF
DOUT0-
DS90UB954
Deserializer
D3+/-
D2+/-
D1+/-
D0+/-
CLK+/-
DOUT0+ RIN0+
RIN0-
0.015 µF
50 Ÿ
0.015 µF
50 Ÿ
Figure 2-1. Typical Application Block Diagram Using DS90UB953-Q1 and DS90UB954-Q1 (or variant)
Quick Start Guide www.ti.com
4 DS90UB95x-Q1 Serializer Evaluation Module SNLU224C – SEPTEMBER 2017 – REVISED APRIL 2021
Submit Document Feedback
Copyright © 2021 Texas Instruments Incorporated