Texas Instruments DS320PR412-421EVM, User Manual

Page: 10 / 31

2.10 Quick-Start Guide (Pin Mode)
Check that the shunts are at the following positions as shown in Table 2-10 .
Table 2-10. Pin Mode Shunt Configuration
SHNT# HEADER SHUNT ACROSS
PINS
1 J1 - J4 1-2
2 JMP7 1-2
3 JMP8 2-3
4 JMP17 2-3
5 JMP18 2-3
6 JMP19 2-3
7 J17 1-2, 3-4
8 J18 1-2, 3-4
9 J19 1-2, 3-4
10 J20 1-2, 3-4
11 J21 1-2, 3-4
12 JMP1 1-2
13 JMP2 3-4
14 JMP3 1-2
15 J30 N/C
16 J23 N/C
17 JMP4 1-2
18 JMP5 3-4
19 JMP6 1-2
20 J24 N/C
21 J25 N/C
22 JMP9 1-2
23 JMP10 3-4
24 JMP11 1-2
25 J26 N/C
26 J27 N/C
27 JMP14 1-2
28 JMP15 3-4
29 JMP16 1-2
30 J28 N/A
31 J29 N/A
The redrivers are configured to operate in Pin Mode (MODE pins tied to L0).
1. RX_Detect state machine of all redrivers is enabled by leaving RX_DET pin open.
2. The redrivers are enabled (PWDN pins tied to GND).
3. The board is configured for any PCIe bus width.
4. DC Gain of all redrivers is set to 0 dB by leaving the GAIN config pin open for the redrivers.
5. EQ level is set to CTLE index 5.
6. If necessary, adjust EQ levels of the downstream and upstream redrivers.
7. Plug the EVM into a PCIe x16 server motherboard slot. Ensure the motherboard is powered down before
installing the EVM or configured for hot-plug operation.
8. Install a compatible PCIe endpoint card into one of the PCIe connectors on the EVM based on configuration
of the SEL pin. Note: PCIe-A requires enabling bifurcation on the motherboard.
9. Power-up the motherboard.
Description www.ti.com
10 DS320PR412-421EVM User's Guide SNLU301 – NOVEMBER 2021
Submit Document Feedback
Copyright © 2021 Texas Instruments Incorporated