Texas Instruments DLP LightCrafter 6500, User Manual, Page: 28 / 60

System Settings
www.ti.com
28 DLPU028C – October 2014 – Revised November 2016
Submit Documentation Feedback
Copyright © 2014–2016, Texas Instruments Incorporated
Operating the DLP LightCrafter 6500 and 9000
• Sequence Abort Status Flag – The box is checked whenever a sequence abort has occurred.
Sequence abort may occur during any pattern mode in preparing a pattern sequence and the timing of
reading the status. Additional status reads may be needed to get a correct state of this indicator. If the
box continues to be checked, it could indicate an error condition in the pattern sequence.
• Sequence Error – The box is checked whenever a sequence error has occurred. Sequence errors may
occur during any of the pattern modes in preparing a pattern sequence and the timing of reading the
status. The user may need to perform additional reads of the status to get a correct state of this
indicator. If the box continues to be checked, this could indicate an error condition in the pattern
sequence.
• DMD Micromirrors Parked – The box is checked whenever the DMD micromirrors are parked.
• Sequencer Running – The box is checked whenever the sequencer is running.
• Video Running – The box is checked whenever video is running normally.
• Locked to External Source – The box is checked to indicated that the EVM has locked to an external
parallel RGB video source. If the EVM loses the locked signal at any time, the box will become
unchecked. A locked source must be present to switch to Video Pattern Mode.
3.4 System Settings
Click the System Settings button at the top of the GUI to display the System Settings panel shown in
Figure 3-2 .
Figure 3-2. System Settings Panel