10
SLVUBH5 – October 2018
Copyright © 2018, Texas Instruments Incorporated
Software Instructions
Appendix A
SLVUBH5 – October 2018
Software Instructions
A.1
IPG-UI Software Installation
The following instructions explain how to install the IPG-UI software on a computer. If this software is
already installed, this section may be skipped.
To install the IPG-UI software, first download the
software installation package from www.ti.com.
Then unzip and install the IPG-UI software tool onto the computer.
A.2
IPG-UI Setup for BOOSTXL-TPS65218
The following instructions explain how to run, setup, and operate the IPG-UI software on a computer and
connect it to the BOOSTXL-TPS65218.
•
Install a shunt on header J20, shorting pin 1 (USB_3P3V) and pin 2 (MSP_3P3V).
•
Run the IPG-UI software by using the Windows
Start Menu
and navigating to the Texas Instruments
folder, or by double-clicking the desktop icon, as shown in
Figure 5. Run the IPG-UI Software
•
Wait for the program to load.
•
Plug in the micro-USB cable to J21 and connect the other end of the USB cable to an open USB2/3
port on the computer.
•
Verify that the software is connected to the USB2ANY as shown in
Figure 6. Successful Connection Between Computer and USB2ANY
•
Click the drop-down menu in the
Create New Project
section and select
TPS65218D0-spi-1.x
as
shown in
