15
16
Install the controller and PSU in the frame. Items required are found
from slot A-04 and bag A-04. Use the M5x8 bolt and T-nut to attach
controller to middle extrusion as shown.
Install the M5x8 bolts and T-nuts as shown. Slide the PSU in extrusion
as far as it goes and tighten the bolts.
Loop the GT2 belt around idler and motor pulley and connect both
ends to slots in heatbed carriage with zipties. Last step is to tighten
the belt which can be done by loosening slightly two M5 bolts hold-
ing idler plate in extrusion and sliding idler plate so that belt tightens
and then tightening the bolts again.
Controller, PSU and front panel installation
Finalizing the assembly A-01, A-02, A-03, B-02, B-03
GT2 belt
M5 T-nut
M5x8 bolt
M5x8 lowprofile bolt
T-nut
Ziptie
Summary of Contents for Tarantula Pro
Page 1: ......
