Read me first
READ THIS MANUAL COMPLETELY BEFORE ASSEMBLING
AND POWERING UP YOUR PRINTER!
Hazards and Warnings
The TEVO Tarantula Pro 3D printer has motorized and heated parts.
When the printer is in operation always be aware of possible hazards.
Burn Hazard
Never touch the extruder nozzle, or the heater block without first
turning off the hotend and allowing it to completely cool down. The
hotend can take up to twenty minutes to completely cool down. Also,
never touch recently extruded filaments. The filament can stick to
your skin and causes burn.
Fire Hazard
Never place flammable materials or liquids on or near the printer
when powered on or in operation. Liquid acetone and vapors are
extremely flammable.
Pinch Hazard
When the printer is in operation, be careful never to put your fingers
in the moving parts, including the belts, pulleys, gears, wheels or
leadscrews.
Static Charge
Make sure to ground yourself before touching the printer, especially
the electronics. Electrostatic charges can damage electronic compo-
nents. To ground yourself, touch a grounded source.
Age Warning
For user under the ages of 18, adult supervision is recommended.
Beware of choking hazards around children.
Contents
Read me first
01
Contents
02
TEVO support
03
Specification
04
Packing list
05
Assembly of the bottom frame A-01
09
Front panel assembly A-02
11
Y axis parts preparation A-03
12
Bed carriage assembly B-02
13
Finalizing
the
assembly
A-01,
A-02,
A-03
,
B-02 and B-03
14
Controller, PSU and front panel installation
16
Hotbed assembly
18
X axis assembly left side B-03
19
Right side and hotend assembly B-04
21
Upper frame assembly
24
Z axis assembly B07
25
Hotend assembly B-04 and B-05
31
Bed leveling
32
Prepare Slicing Software
33
How to Slice 3D Object for SD Print
40
How to Flash Firmware
42
Troubleshooting
43
Tevo After-Sales
45
01
02
Summary of Contents for Tarantula Pro
Page 1: ......
