Tevion UR4200, Instruction Manual, Page: 8 / 28

After Sales Support TEL: 1300 663 907 After Sales Support TEL: 1300 663 907
7 20
While sending a command by pressing a button, the display
and buttons backlight illumination will turn off. As soon as
you release the button the backlight illumination will turn on
again. This is not a fault: it has been designed to maximise
the transmission range.
The described button functions are available only whenever
the programmed device supports these functions.
Inserting the Batteries
Open the battery compartment cover on the back of the
remote control by pressing firmly on the triangular shaped
thumb grip and sliding the cover down off the end of the
remote.
Insert the supplied batteries (size AA) into the remote control.
Take note of the battery polarity when inserting batteries. The
correct polarity is indicated on the diagram within the battery
compartment.
To replace the battery cover, slide the battery cover in the
opposite direction, onto the remote control until it clicks into
place.
Programming VPT Manually
If you want to control the volume of a specific device
individually (not using VPT), this must be programmed
manually.
Example:
You are using the remote control for a satellite
receiver too. For all devices, VPT controls the
volume via the TV set, but the sat receiver has
its own volume control that you want to use.
For manual programming, proceed as follows:
1. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the SET
button (21).
2. Press (8) three times. The display shows [VPT SETUP].
3. Press the OK button (22). The display shows [TO DEV].
4. Press the source device selection button (2) of the device
for which you want to override the volume control (e.g.
STB). The display shows [FROM DEV].
5. Press the source device selection button (2) of the device
that you want to use for volume control (in this example
also STB). The message [SUCCESS] will appear for a few
seconds and the device returns to the [VPT SETUP] level.
6. Quit the process by pressing the EXIT button (23).
Please note that using VPT overrides any manually-learned
key functions.