Tevion UR4200, Instruction Manual, Page: 16 / 28

After Sales Support TEL: 1300 663 907 After Sales Support TEL: 1300 663 907
9. As soon as the TV set powers off, press the PAUSE button
(12). This will interrupt the automatic search.
If you have pressed the PAUSE button (12) too late,
you can use the button (8) to return step by step
to the previous device codes to check them again. If
these device codes do not work, you can use the
button (8) to go back to the device code where the
scan was stopped. As soon as the TV set powers
back on, the proper device code has been found.
10. Press the OK button (22) to save the device code. The
message [SUCCESS] will appear for a few seconds and
the device returns to the previous menu [AUTO SRCH].
11. Quit the programming mode by pressing the EXIT button
(23) twice.
If the TV set fails to respond properly, repeat the
automatic search. Then skip the already-setup device
code. You may for instance cover the remote control
transmitter at the front of the remote control when
the wrong code number is going to be sent.
It is possible that no proper device code is found.
In this case, try to program the remote control by
using the learning function and the original remote
control unit.
5. Press (8) twice. The display shows [DELETE DEV].
6. Press the OK button (22). The display shows [SELECT DEV].
7. Press the source device selection button (2) of the device
for which you want to erase all programmed information.
The display shows [SURE DELET].
8. Press the OK button (22) to confirm the deletion.
If there is a large number of assigned key codes, the
deletion may take some time. During this process,
the display will show [WAITING].
9. The message [DELETED] will appear for a few seconds
and the device returns to the previous menu
[SELECT DEV].
10. Quit the process by pressing the EXIT button (23)
three times.
Erasing All Learned Key Codes
This function allows you to erase all manually learned key
commands for all devices. Any buttons that have been
programmed via a device code will not be erased.
1. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the
SET button (21).
2. Press (8) twice. The display shows [LEARNING].
3. Press the OK button (22). The display shows [LEARN KEY].
4. Press (8) three times. The display shows [DELETE ALL].
5. Press the OK button (22). The display shows
[SURE DELET].
6. Press the OK button (22) to confirm the deletion.
If there is a large number of assigned key codes, the
deletion may take some time. During this process,
the display will show [WAITING].
7. The message [DELETED] will appear for a few seconds and
the device returns to the previous menu [DELETE ALL].
8. Quit the process by pressing the EXIT button (23) twice.
15 12