13
·
Concept S SW + R Dolby Digital/dts
Q
Power
Switches the subwoofer on (press once) or off
(press again), after the power supply has been
switched on at the rear of the device (“Power” –
see page 11).
W
Mute
Pressing the button once immediately mutes the
complete system; if you press it again, the system
returns to its previous operating status. If the
system has been switched to mute, the “MUTE
ON” message on the display lights up; upon reac-
tivation “MUTE OFF” lights up briefly before the
input source appears again, e.g. “OPT”.
E
Choice of input
Select the five inputs plus the integrated radio
receiver here.
ĕ
Page 20
R
Station buttons
Nine buttons allow direct selection of the radio
stations saved by the user
ĕ
Page 21
T
Station buttons switch
Allows programming of additional radio presets.
Press once for positions 11–19, twice for 20–29, 3
x 30.
ĕ
Page 21
Y
stereo/Mono switch
When receiving weaker VHF/FM stations via room
aerials, the playback quality may improve notice-
ably if you switch to mono.
U
Mem
Memory button to assign the station buttons (4).
ĕ
Page 21
I
Scan
For radio operation you can scan through the
frequency bands manually to get to the next
station – in ascending [+] or descending [-] order.
ĕ
Page 21
O
Channel
In “Tuner” mode you can switch directly from sta-
tion to station – in ascending [+] or descending [-]
order
ĕ
Page 21
P
C.Delay
Option to set the delay on the centre speaker.
Only works with Dolby Digital/dts.
ĕ
Page 19
{
Test
Initialises the test sound to equalise the speakers.
ĕ
Page 18
}
Night Mode
Activates reduced-volume playback for Dolby Dig-
ital signals with sound adjustment at low volume
levels. Press again to deactivate Night Mode.
ĕ
Page 20
q
Listen Mode
Used to select the various playback modes, such as
Dolby Prologic II or stereo. If a Dolby Digital signal
is active, stereo mode is forced by pressing this
button.
ĕ
Page 20
w
Reset
Call up the subwoofer’s factory settings using
this button.
e
S.Delay
Allows adjustment of the rear speaker time delay.
Only works with Dolby Digital/dts and Dolby Pro-
Logic II.
ĕ
Page 19
r
Centre/Woofer
Use the [+] and [-] buttons to adjust the required
levels of the centre and subwoofer.
t
Bass
Use the [+] and [-] buttons to adjust the required
bass level. It acts directly on both front speakers.
y
Treble
Use the [+] and [-] buttons to adjust the required
treble level. This sound adjustment acts directly
on both front speakers.
u
This increases the overall volume.
i
Volume -
This reduces the overall volume.
o
Balance »L« »R«
The “L” and “R” buttons increase the respective
amounts of equalisation of the left (“L”) or right
(“R”) front speakers. Pressing the “Balance” but-
ton will return the equalisation to the original
balanced state.
p
Rear
Use the [+] and [-] buttons to regulate the re-
quired levels of the left and right rear speakers.
Tip:
The settings you make are
saved directly by the subwoofer
without any need for further
action. They will still be available
even after disconnection from
the electricity supply.
Operating elements: Remote control
