Tetra Pak HOYER COMET C, Manual

Page: 30 / 150

CC901AE
5-13
Tetra Pak
Hoyer
Fig. 5.9
2
1
4
3
Fig. 5.9a
3
4
2
1
5.3.7 Lid feed station adjustment
5.3.7a Optional flame product lid closing stationa adjustment
Make sure that the lid feed station is switched
off (button (Fig. 5.14) in OFF position) with
the suction cups in the raised position.
Check that the suction cups (Part. 1, Fig. 5.9)
are in direct contact with the lids inside the
magazines. If not, turn the lifting cylinder rod
(Part. 2, Fig. 5.9) clockwise (within the block)
in order to raise the suction cups (Part. 1, Fig.
5.9) until they are in direct contact with the lids.
To adjust height, loosen the lock nut (Part. 1,
Fig. 5.9) and turn the ring nut (Part. 2, Fig. 5.9)
to correct position (turning it clockwise to
increase the stroke of the pneumatic actuator or
anticlockwise to decrease it).
Tighten the lock nut (Part. 1, Fig. 5.9) when
finished.
With the machine at its slowest speed, check that
when the lid feed station is activated, the suction
cup mounting shaft drops down immediately after
the lamella chain has stopped, and then check
that it moves back up before the chain starts
moving again..
To adjust height, loosen the lock nut (Part. 1,
Fig. 5.9a) and turn the ring nut (Part. 2, Fig.
5.9a) to correct the position (turning it clockwise
to increase the stroke of the pneumatic actuator
or anticlockwise to decrease it).
Tighten the lock nut (Part. 1, Fig. 5.9a) when
finished.
To centre the station so that lid magazines are
aligned with slots loosen the screws holding the
magazine supports in place and adjust position
using the slots (Part. 3, Fig. 5.9a).
Tighten the screws holding the supports in place
when finished.
Adjust the position of the lid pick-up gripper
control actuator holder supports (Part. 4, Fig.
5.9a).