TESTO 350 M/XL, Getting Started

Page: 32 / 40

5. Setting up Control Unit and analyser box measurement system 32
5.1. Setting up bus address
· Bus connection is set up for one analyser box.
· Measurement menu is activated.
Every instrument has a default bus address which makes it easy to identify. The bus
address consists of a two-digit number which is assigned as follows:
· Control Unit
Always 01 ex factory
· Analyser box 10 to 20 ex factory
All bus ID addresses have to be different.
If the bus address is the same, it has to be changed!
2 Select –> .
3 Select digit and the value takes effect if is pressed.
If high numbers are selected, it can take a while for the analyser box to be recognised
when first switched on.
4 The bus address applies once is activated.
5.2 Selecting instruments
· Measurement menu is activated.
1 Open system configuration with
.
- The system configuration with the Control Unit and all connected components
(logger, analyser box, analog output box, powerbox) is shown.
2 Select instrument and confirm with .
- The reading display of the selected instrument appears.
5.3 Setting the language
· Control Unit is selected.
· Measurement menu is activated.
1
Open main menu.
2 Select –> or .
- The selected language setting is displayed.
3 Select language and confirm with
.
5.4 Setting the date/time
· Control Unit is selected.
· Measurement menu is activated.
1 Select –>
.
2 Select date or time using or .
3 Activate setting mode using .
4 Select digit and the value applies once is activated.
5 The date/time comes into effect once is activated.
If a measuring program is activated, the date and time entries are locked. The message
appears.
Meas. p program aactive
End
Edit
Change d date Device
Lang. Sprache Service
Finish
Bus aaddress Service
5. Setting up Control Unit and analyser box measurement system
Select digits
in the date
line