Air Entrainment Meters
0.5 litre; model: TESTING 1.0334 0,75 litre; model: TESTING 1.0337
1 litre; model: TESTING 1.0335 5 litre; model: TESTING 2.0332
7 litre; model: TESTING 2.0337 8 litre; model: TESTING 2.0334
Page 12 of 42 pages
II
. Test pot
Test pot for filling the material to be tested; clamping ring with handles
The outside of the air entrainment meters is an enclosure made of anodized cast
aluminium. The upper part and the test pot are held together, air-tight, by quick-release
latches. The water is filled in through the two ball shut-off valves, and air-pressure release
takes place through these same valves.
The compressed air is produced by a hand pump installed in the air entrainment meter. A
correction valve (with the black rubber cap) for setting the initial pressure and the overflow
valve (with the green rubber cap) are located on the cover of the entrainment meters. The
overflow valve and the correction valve are operated by pressing the proper buttons. The
pressure gauge is also mounted on this top part of the air entrainment meter, in a protected
position. The scale of the pressure gauge reads from 0 to 100 %.
Clamping
ring with
handles
Test pot
