TestEquity FOV Series, Installation & Operation Manual

Page: 26 / 43

26 | P a g e
OPERATION
Note: The oven may produce light smoking during its first use above 150°C as the remnants of a
protective oil coating burn off the heating element.
P
UT THE
O
VEN INTO
O
PERATION
Carry out the following steps and procedures to put the oven into operation after installing it in a
new workspace environment.
End of procedure
1
2
Attach the power cord that came with the unit to the power inlet
receptacle on the back of the oven.
Plug the power cord into the workspace electrical supply outlet.
3
Place the oven
Power Switch in the on ( I ) position.
•
The switch will illuminate.
•
The Temperature display will illuminate.
4
Set the Temperature the Set Point . See page 27.
•
Set the oven temperature to your baking application
temperature.
5
Optional : If you are required to verify the accuracy of the temperature
display for regulatory or industry standards compliance, see the set up
and first step of the suggested Calibrate the Temperature Display
procedure in the User Maintenance chapter. See page 34.
6
Set the Over Temperature Limit . See page 28.
The oven must be heated and and stable at temperature to
perform this procedure.
