TestEquity FOV Series, Installation & Operation Manual

Page: 27 / 43

27 | P a g e
OPERATION
S
ET THE
O
VEN
T
EMPERATURE
S
ET
P
OINT
Adjust the oven temperature set point to that of your application.
End of Procedure
1
Turn the OTL dial clockwise to its max setting, if not already set at
max.
•
This prevents the heating cutoff system from interfering with this
procedure.
2
Activate the temperature set point adjustment mode.
a. Press and release either of the Set
Temperature arrows
•
The display will briefly flash the letters “SP”, then show
the flashing, adjustable temperature set point.
Note : The display will automatically exit the adjustment mode after 5
seconds of inactivity, with the last shown set point value saved.
Set Temperature
Set Point Adjustment Mode
Current Set Point
3
Adjust the set point to your application temperature using the
Up or
Down arrow buttons.
Set Temperature
New Set Point
4
Wait 5 seconds after entering the set point.
•
The display will stop flashing. The set point is now
saved in the controller.
•
The oven will now automatically heat or passively
cool to match the set point.
•
The display will revert to showing the current
chamber air temperature.
Set Temperature
Heating to Set Point
See the
Setting the Over Temperature Limit procedure
on page 28 for how to
set the OTL heating cutoff system once the oven has stabilized at your application
temperature set point.