2/4
COPYRIGHT NOTICE
No part of this document may be reproduced, republished, translated or digitalized in any form or by
any means, without prior written permission of TESLA.
Information contained in this manual relates exclusively to the TERA system component specified on the
title page. New versions and modifications may be developed without prior notice to current users. TESLA
has made every attempt to provide you with complete, error-free and accurate information in this manual.
TESLA is not liable for errors or omissions contained in this document, or for any damages however resulted
from using or relying on any information contained herein. TESLA's liability for errors shall be strictly limited
to correcting such errors and providing advisory services as described below.
Users should be familiar with operation basis of used product. If you experience any problems with your
product, please contact us at:
TESLA
Rubeska 215/1
190 00 Prague 9 - Vysocany
1
Introduction
This document describes technical specifications and user operation of TPS2 Power Relay.
The product was developed and manufactured in the Czech Republic. All rights reserved TESLA. Offer or
delivery of products or services related to the product does not include transfer of ownership rights.
Before using the product, please read this manual carefully and understand all operating and safety
precautions. Compliance with operational and safety precaution can prevent from damage to equipment or
injuries to personnel. Operating and safety instructions in the document are marked as follows:
Attention!
This formatted text indicates the operating and safety instructions.
The product may only be used in the specified manner and for its intended purpose. The product may be
provided to third persons along with this documentation only.
2
Description and Utilization
Power element is basically made up of high power switching which is controlled by the Actuator output
or the Central Unit output. Actuator and Central Unit are parts of TERA program made by TESLA; see
–
contacts of actuator (central)
memory relay switch voltage on power relay coil. Power relay
is mostly located near an actuating unit (fan,
recuperation unit, etc.). By a switch on box of power relay it is possible to choose permanent switching of
relay
–
position ´ON´
or choose switching of relay by automatic control signal
–
position
´
AUT
´
.
TPS2 Power Relay can be used in this system:
TERA System for Radon Concentrations Regulating (Figure 1)
Regulating system diagram description
- Radon measuring probes located in building transmit their
current radon concentration values to central unit wirelessly. Central unit analyzes this information and on
the basis of measured (set) concentration level value it sends wireless command to actuator which is
hardwired with power relay. Power relay switches on a fan which decreases radon concentration within an
area. After decreasing of radon concentration, actuator receives a command to switch off the fan. This cycle
repeats depending on increasing or decreasing volume activity of radon in building.