Tesla TM28AF21-0932IAW, User Manual

Page: 10 / 169

39
ENG
Follow me function ( ):
The FOLLOW ME function enables the remote control
to measure the temperature at its current location and
send this signal to the air conditioner every 3 minutes
interval.
When using AUTO, COOL or HEAT modes, measuring
ambient temperature from the remote control(instead
of from the indoor unit itself) will enable the air
conditioner to optimize the temperature around you
and ensure maximum comfort.
NOTE : Press and hold Turbo button for seven seconds
to start/stop memory feature of Follow Me function. If
the memory feature is activated,
“On” displays for 3
seconds on the screen.
• If the memory feature is activated,
“On” displays for
3 seconds on the screen
• If the memory feature is stopped, “OFF” displays for
3 seconds on the screen.
• While the memory feature is activated, press the ON/
OFF button, shift the mode or power failure will not
cancel the Follow me function.
AP function ( ) :
Choose AP mode to do wireless network configuration.
For some units, it doesn’t work by pressing the SET
button. To enter the AP mode, continuously press the
LED button seven times in 10 seconds.
Breeze Away function ( ) (some units) :
This feature avoids direct air flow blowing on the body
and makes you feel indulging in silky coolness.
NOTE : This feature is available under cool, Fan and Dry
mode only.
FRESH function ( ) (some units) :
When the FRESH function is initiated, the Ionizer/Plasma
Dust Collector(depending on models) is energized and
will help to remove pollen and impurities from the air.
Keep pressing Fan button for more
than 2 seconds to activate/disable
Silence Function (some units).
Due to low frequency operation
of compressor, it may result in
insufficient cooling and heating
capacity. Press ON/OFF, Mode,
Sleep, Turbo or Clean button while
operating will cancel silence function
Press LED button
Press this button to turn on and turn
off the display on the indoor unit.
Press this button more than 5
seconds(some units)
Keep pressing this button more than
5 seconds, the indoor unit will display
the actual room temperature.
Press more than 5 seconds again
will revert back to display the setting
temperature.
Press X-ECO button to enter the
energy efficient mode in a sequence
of following:
ECO -> GEAR(75%) -> GEAR(50%) ->
Previous setting mode -> ECO......
Note:This function is only available
under COOL mode.
Silence function
LED DISPLAY
ECO operation:
Under cooling mode, press this button, the remote
controller will adjust the temperature automatically
to 24
º C/75 º F, fan speed of Auto to save energy (only
when the set temperature is less than 24 º C/75 º F). If
the set temperature is above 24 º C/75 º F, press the
ECO button, the fan speed will change to Auto, the set
temperature will remain unchanged.
NOTE :
Pressing the ECO button, or modifying the mode or
adjusting the set temperature to less than 24
º C/75 º F
will stop ECO operation.
Under ECO operation, the set tmeperature should be
24
º C/75 º F or above, it may result in insufficient cooling.
If you feel uncomfortable, just press the ECO button
again to stop it.
GEAR operation:
Press the ECO/GEAR button to enter the GEAR
operation as following:
75%(up to 75% electrial energy consumption)
50%(up to 50% electrial energy consumption)
Previous setting mode.
Under GEAR operation, the display on the remote
controller will alternage between electical energy
consumption and set temperature.
ECO/GEAR function