10
ENG
Out of operation
TROUBLESHOOTING
• Power failure: In case of power failure, even if it is in summer, foods inside the appliance can be kept for
several hours; during the power failure, the times of door opening shall be reduced, and no more fresh
food shall be put into the appliance.
• Long-time nonuse: The appliance shall be unplugged and then cleaned; then the doors are left open
to prevent odor.
• Moving: Before the refrigerator is moved, take all objects inside out, fix the glass partitions, vegetable
holder, freezing chamber drawers and etc. with tape, and tighten the leveling feet; close the doors and
seal them with tape. During moving, the appliance shall not be laid upside down or horizontally, or be
vibrated; the inclination during movement shall be no more than 45°.
The appliance shall run continuously once it is started. Generally, the operation of the appliance
shall not be interrupted; or otherwise the service life may be impaired
You may try to solve the following simple problems by yourself. If them cannot be solved, please contact
the after-sales department.
Failed operation
Check whether the appliance is connected to power or
whether the plug is in well contact.
Check whether the voltage is too low.
Check whether there is a power failure or partial circuits have tripped.
Odor
Odorous foods shall be tightly wrapped.
Check whether there is any rotten food.
Clean the inside of the refrigerator.
Long-time operation
of the compressor
Long operation of the refrigerator is normal in summer
when the ambient temperature is high.
It is not suggestible having too much food in the appliance at the same time.
Food shall get cool before being put into the appliance.
The doors are opened too frequently.
Light fails to get lit
Check whether the refrigerator is connected to power supply and whether
the illuminating light is damaged.
Have the light replaced by a specialist
Doors cannot be
properly closed
The door is stuck by food packages The refrigerator is tilted
Loud noise
Check whether the floor is level and whether the refrigerator is placed stably
Check whether accessories are placed at proper locations
Door seal fails to be
tight
Remove foreign matters on the door seal
Heat the door seal and then cool it for restoration (or blow it with an
electrical drier or use a hot towel for heating)
Water pan overflows
There is too much food in the chamber or food stored contains too much
water,resulting in heavy defrosting.
The doors are not closed properly, resulting in frosting due to entry of air
and increased water due to defrosting.
Hot housing
Heat dissipation of the built-in condenser via the housing, which is normal.
When housing becomes hot due to high ambient temperature and
storage of too much food,it is recommended to provide sound ventilation
to facilitate heat dissipation.
Summary of Contents for RS2000M
