TESI XE18PB06, Instructions For Use And Maintenance Manual

Page: 46 / 66

PORTABLE HIGH-ENERGY IGNITER
– XE18PB06 - Rev.00
45
Table 6.1 describes the commands and controls placed on the panel
Table 6.1 - Commands and controls placed on the control panel and control
POS. PLATE TYPE FUNCTION
1 IGNITION Red button Press to activate the spark.
2 CHARGING Green light Indicates (if illuminated) when the
device's internal battery is under
recharge
3 BATTERY LEVEL Multicolored led
Indicate the remaining battery power
during operation of the red button.
GREEN: Remaining including between 51%
and 100%.
ORANGE: Remaining between 21% and 50%.
RED: Charging below 20%.
It is necessary to recharge the internal
battery
6.3 USE
TESI s.r.l. developed this device for facilitating the ignition of the burners, without its own dedicated system
(pilot torches or other).
The device 'is also a good resource in case of emergency or breakdown of main igniters.
High power discharge also allows easy ignition of liquid fuels.
Not affected by the presence of moisture or deposits that can stain the surface of the electrode.
The combination of mechanical and electrical generation of spark makes self-cleaning the surface of the
spark ignition electrode.
6.3.1. POSITIONING OF IGNITION IN THE BURNER
Before operating the spark button should place the ignition lance inside the burner, through appropriate
openings available.
Make sure the ends (tip) of the igniter is close to the release of fuel from the nozzle of the burner.
If installed use the sliding stop flange (optional) to set the correct position for future applications.
6.3.2. UNIT IGNITION STARTING
Press the button to allow the release of the spark to the igniter tip.
Possibly move the igniter increasing or decreasing the depth of insertion to facilitate ignition of the burner.
Discharge cycle admitted: not continuous cycle, max duty 33% (for example 10seconds working -
20second rest), maximum continuous working 120 seconds.