19
Troubleshooting
Some typical malfunctions and possible reasons:
System cannot be switched on:
Control the fuse in the red power line. Control the connection
between panel and control unit. Try it with another network cable.
LED START does not light up
: one of the limit switches is not correctly adjusted. Control all
switches and adjust them like shown on page 11.
The vehicle is not in balance after using AUTO:
The correct level is stored in the control unit.
Nevertheless it is possible the balance is not correct if the control box is fitted incorrectly an in
false position. Correct the position of the box and store a new level like shown in the next chapter.
Storing the correct levelling
The fault tolerance of automatic levelling is about 0.3° in both directions. Use this procedure only
if you want a better result of automatic levelling.
1.
Use the function MANUAL, controlled with spirit level
2.
Switch off the system.
3.
Switch on system again and right after that press and
hold AUTO - MANUAL - GET-UP at once until 7 beeps from the panel.
4.
Release the buttons, the level is stored.
Emergency operation
In case of damage a tone jack the malfunction is shown on the panel by the related LED and the
function GET UP is not available. Please use following instruction to put the jacks in driving
position:
1.
Switch over to “calibration mode” like described in the
chapter adjustment of limit switches on page 10
2.
Bring all jacks separately to the driving position.
In case of a mechanical damage at the jacks or total electrical breakdown use the following
instructions to put the jacks into driving position:
Use the car-jack from the vehicle equipment and lift the vehicle until the jack is released from the
floor. Clap the jack manually into driving position and fix it with cord, wire or the like in this
position. Inform your dealer / garage to solve the problem.
Summary of Contents for Auto lift system
Page 21: ......
