TES E-TES SD, Operator'S Manual

Page: 28 / 55


Copyright Tes Drying Systems, 2014
28
Problem
Cause Solution
Circuit
Breaker
Both cords on one circuit Move one cord to a separate circuit
Blowing Too much current demand on circuit
Move plug to another outlet & circuit or disconnect other
devices from this circuit.
Circuit breaker faulty
Move plug to another outlet & circuit or have electrician
replace circuit breaker
Heating Element faulty Replace Heating Element
Faulty power cord Replace cord NM4407
Faulty switches or internal wiring Check wiring & test switches - Repair as needed *
Unit Not
Heating
Heater Switch in OFF position Turn switch to ON position
Building circuit breaker tripped. Reset breakers or move cords to other outlets
HEATING GFCI tripped Reset GFCI
Light OFF Faulty power cord Replace cord
(GREEN) Faulty GFCI Replace cord (NM4407A) or replace GFCI
Air Mover not running
Turn on air mover or check power to air mover.
Repair or replace air mover as needed
Low Air Flow Remove restrictions to maintain adequate air flow
Probe Temperature set too low Reset Air Temp & Surface Temp set points
Moisture 1 or 2 set point too low Reset Moisture Value set points
Moisture 1 or 2 Value stuck at zero With probe connected, turn Power switch OFF then ON
Faulty Remote probes Check probe readings – Replace probes as needed
Internal Temperature sensor faulty Replace circuit board
Faulty Snout Temperature Sensor Replace Snout Temperature Sensor
Faulty switches or internal wiring Check wiring & test switches - Repair as needed *
Faulty Safety Temperature Switch
Observe Lights to determine function
Correct condition or Repair as needed *
Faulty indicator light Replace light
POWER Heater Switch in OFF position Turn switch to ON position
Light OFF Building circuit breaker tripped. Reset breakers or move cords to other outlets
(GREEN) GFCI tripped Reset GFCI
Faulty power cord Replace cord
Faulty GFCI Replace cord (NM4407) or GFCI
Faulty switches or internal wiring Check wiring & test switches - Repair as needed *
Faulty indicator light Replace light
Start-Up Memory Locked Up Re-initialize Memory (See page 33)
Error Software Corrupted Reprogram processor (See page 19)
Display Circuit Board Faulty Replace circuit board
Section
3
* To reduce the risk of injury, repairs to electrical systems should only be performed by experienced
technicians. Contact your nearest service center for assistance.
E-TES SD Troubleshooting