Copyright Tes Drying Systems, 2014
25
For the E-TES SD unit to heat up, both
the POWER light and HEATING light
must be on.
7)
Set the Remote Sensor activation points at the temperature or moisture level required for your application.
(See SECTION 2 for Instruction on how to set activation points.)
8)
If you are planning using the data files which the E-TES SD will log during this job, check the current date &
time on the E-TES SD display. Set time & date to correct settings.
(See SECTION 2 – Page 13 for Instruction on how to set the date & time.)
Once set to the correct date & time, turn the E-TES SD OFF & then back ON to start new job file with
correct start time & date.
9)
Place an air mover into the E-TES SD unit. Plug in the air mover and turn the air mover switch ON.
10)
Observe indicator lights. When both green lights are illuminated system is operating properly and the heating
elements are getting power. If the green
HEATING
light is off, the unit is not heating properly.
CORD #2
CORD #1
AIR MOVER
REMOTE AIR
TEMPERATURE
PROBE
OMNIDRY 2.9 AIR MOVER
INDICATOR LIGHTS
