Undercounter RFID Refrigerator User Guide, Rev 5 – 06/18/2021
PN 720509
7
ABOUT THIS MANUAL
Introduction
Read this guide carefully before operating the TS097 Undercounter RFID Refrigerator and follow instructions for
safe operation. Terso Solutions does not guarantee safe operation if the device is not used as intended as outlined
in this guide. The contents of this guide are subject to change without notice due to improvement in performance or
functions.
Contact Terso Solutions’ Technical Support team at +1 888.376.0257 with operation questions or if guide is
lost.
Please make sure you have the device Digital Serial Number (DSN) ready for reference. This DSN is on a label on
the exterior of the device near the “Powered by Terso” label.
Notational Conventions
This document uses the following conventions:
•
Bullets (•) indicate:
- Action items
- Required steps
- Lists of alternatives
•
Numbered lists: indicate a sequential process (i.e. step-by-step procedure).
•
Note:
indicates something of special interest or importance to the reader. Failure to read the note will not
result in physical harm to the reader, equipment, or data
CAUTION
This symbol indicates that if this information is ignored, the possibility of data or material
damage may occur.
PROHIBITED ACTION
This symbol indicates that an action is not a correct or safe use of the device.
PRECAUTIONS FOR SAFE OPERATIONS
It is imperative that the user complies with this guide as it contains important safety advice.
Items and procedures are described so that this device may be used correctly and safely. Following the precautions
advised will prevent possible injury to the user and any other person.
Precautions are illustrated in the following way:
Failure to observe WARNING signs could result in a hazard to personnel possibly resulting in serious injury or
death.
Failure to observe CAUTION signs could result in injury to personnel and damage to the device and associated
property.
This mark is labeled on the cover in which the electrical components of high voltage are enclosed to
prevent electrical shock. The cover should be removed by qualified engineers or service personnel only.