10521 Gulfdale, San Antonio, TX 78216 I
www.terrawave.com
I Email:
I Phone: 210-375-8482
Version 1.1 - Page 6
When installing Ethernet cabling into the TWSD16128PHC, you must remove the pre-
installed NEMA 4 plug in the bottom of the enclosure. To remove the plug, simply loosen the
fly nut located inside the unit. Once the Fly nut has been removed, the plug will fall out of the
enclosure. Replace the plug with conduit. The conduit must be suitable for environmental
and wet locations. Refer the NEC and follow any national or local codes. Refer to figure 4
below.
(Figure 4)
Mounting Plate
The TWSD16128PHC is supplied with a mounting plate to be used for attaching WLAN /
Networking components. The following diagram (figure 1) shows which holes should be used
when attaching approved products to the plate.
NEMA 4 Plug with Fly Nut
