Introduction
30
RangePro RPX8-P User Manual
5 • Assemble RangePro RPX8-P for Flight
Introduction
Refer to the following sections to assemble the UAV for flight:
•
Parts of the Aircraft
•
)
•
Battery Installation (see
•
Payload Installation (see
)
Parts of the Aircraft
The top view of the aircraft is shown in
on page 31. The following are called out in the figure:
•
Front LED (White)
•
Rear LED (Green)
•
Accessory Platform
•
Propeller Mount Screws
•
Propeller Blade Screws
•
GPS Antenna (Raised)
The bottom view of the aircraft is shown in
on page 32. The following are called out in the figure:
•
Radio Antenna SMA Connectors
•
Payload GPS Antenna SMA Connector (one SMA only—not to be confused with the two radio antenna SMA
connectors)
•
Payload Mounting Points
•
Gimbal Plate
•
Gimbal Plate Mounting Standoffs
•
HDMI Video Connection (if so equipped)
•
Breakout Board Ports:
-
Power Out
-
Serial Out
-
Ethernet Out
-
I2C Out
-
SBus Out, not to be confused with SBus In.
-
PWM Out ports 1–6
Summary of Contents for RangePro RPX8-P
