WARNING: Disconnect the plug from the power source before making any
assembly, adjustments or changing accessories. Such preventive safety measures reduce the
risk of starting the tool accidentally.
Assembly
1. Turn the Power Switch off and unplug the tool.
2. Place the attachment over the Spindle, shoulder facing away from the tool. Line up the holes on
the attachment with the pins on the Spindle shoulder.
Note: The Angled Cutter Blade should only be used in the straight ahead position and not an
angled position. (Fig.3)
3. Place the Small Washer and then the Large Washer onto the Cap Screw (cupped side facing up)
(Fig.2). While holding the attachment over the pins on the tool spindle, thread the Cap Screw in
place.
4. Tighten the cap screw onto the Spindle using the provided Hex Key. (Fig.3)
5. After securing, the attachment should not move on the spindle. If it does move with the power
off, remount it, making sure that the holes on the attachment line up with the pins on the spindle.
Tighten the cap screw securely.
On-Off Switch
(Fig.4)
Ensure that the switch is in the “OFF” position. If the plug is connected to a receptacle while the
switch is in the “ON” position, the power tool will start operating immediately and can cause
serious injury.
The tool is switched "ON" by the slide switch located on the topside of the motor housing.
TO TURN THE TOOL "ON", slide the switch button forward.
TO TURN THE TOOL "OFF", slide the switch button backward.
Variable speed control dial
This tool is equipped with a variable speed control dial (Fig.5). The speed may be controlled during
operation by presetting the dial in any one of six positions, 1 being the lowest, and 6 being the
highest.
Using your machine
1. With the tool unplugged, mount the attachment in place.
2. Pull the Power Switch back to its off position. Then plug the Power Cord into the nearest 120
volt, grounded electrical outlet.
3. To turn on the tool, slide the Power Switch forward.
4. Do not allow contact between the Scraper and work piece until the tool is running at full speed.
5. Avoid contact with foreign objects such as metal screws and nails when sanding, scraping, or
cutting.
6. Do not apply excessive pressure on the tool. Allow the tool to do the work.
7. When finished, turn off the tool and allow it to completely stop before setting it down. Then
unplug the tool from its electrical outlet.
8. Prior to storing the tool, remove the attachment and wipe it clean. Store the Tool in a clean, dry,
safe location, out of reach of children and other unauthorized persons.
Maintenance
WARNING: For your own safety, make sure switch is off and unplugged from the power source
before doing any maintenance or adjustments. Replace the power cord immediately if it is cut,
worn, or damaged in any way.
