Copyright
©
2007 Terramite Corporation
2.17
WWW.TERRAMITE.COM/SAFETY
USA 1.800.428.3772
Intl. 1 .304.776.4231
Charleston, WV/USA
PARTS MANUAL
Read Operators Manual For Safety
Service Operations
&
ITEM
DESCRIPTION/LOCATION
MAINTENANCE SCHEDULE
4. Engine Oil
Engine Oil Type:
Refer to Engine
Change Engine oil and all filters, air,
Manufacturers Operations Manual.
spin-on fuel, in-line fuel, and oil every
150 hours.
5. Radiator Water/Anti-
Strictly 50% water and 50% permanent
Check mix and level. Level to be 1/2
freeze
Antifreeze mixture only!!!!
full in plastic over-fill tank.
6. Tire Pressure
45 PSI to 50 PSI
Check Daily.
7. Water Filters
Under Floorboard, Water Tanks
Clean as Needed
8. Front Wheel Bearings
Front Wheel inside and outside.
Repack monthly.
9. Fuel Tank Drain
Pipe plug located in center of and
Drain once a year.
at bottom of fuel tank.
10. Wheel Lock-Out
Between wheel and frame. Remove
Check every 3 months.
Oil Level
female hex plug on front or back of
housing to check.
Capacity:
6 Ounces
Motor Oil:
SW 30 Wt. Detergent
Machine Trouble Shooting & Hydraulic Component
Check-Out
Before testing any hydraulic component always check the
hydraulic oil level. Bring the hydraulic oil temperature up
to 20° over Ambient. Place the machine on a flat surface.
The hydraulic oil level should be in center of the "Eye"
indicator and/or not more than 1" below the top surface of
hydraulic oil tank.
Lubrication and Maintenance Chart (continued)
Service and Maintenance Points
All references to "Left" or "Right" side of the Terramite
Street Sweeper are stated as from the Operators seat
facing forward.
Anti-Freeze Mix
Liquid cooled engines are very sensitive to the water/
antifreeze mix. To much of either water or antifreeze will
cause engine overheating. The proper mix is 50% water
and 50% antifreeze.
Air cooled engines have no need for anti-freeze.
