Copyright
©
2007 Terramite Corporation
2.19
WWW.TERRAMITE.COM/SAFETY
USA 1.800.428.3772
Intl. 1 .304.776.4231
Charleston, WV/USA
PARTS MANUAL
Read Operators Manual For Safety
Service Operations
&
Broom Core Removal/Wafer Replacement
1. Place sweeper in level spot.
2. Engage parking brake
3. Turn off engine.
4. Clean the broom head.
5. Lower the sweeper head until the bristles just touch
the surface.
6. Remove the 3 bolts (Shown as “A” in Figure 1).
7. Remove the bolt (Shown as “B” in Figure 1).
8. Pull the motor assembly from the brush core and lay
it to the side.
DO NOT REMOVE ANY HOSES!
9. Start the sweeper at low idle. Raise the broom head
enough to allow the core to be completely removed.
Turn off engine.
10. If turning the broom for brush life, rotate broom core
and skip to step. 16.
11. Remove the (2) screws and cap plate (Shown as
“A” in Figure 2).
B
FIGURE 1
FIGURE 2
A
FIGURE 3
Proper Placement
of Drive Pins (Circled)
FIGURE 4
Improper Placement
of Drive Pins (Circled)
FIGURE 5
Proper Placement
of Wafers on Core
FIGURE 6
Improper Placement
of Wafers on Core
12. Remove wafers.
13. Place a wafer onto the core with the drive pins
between the tube (Shown in Figure 3 for proper
placement and Figure 4 for improper placement).
14. The next wafer is flipped as it is placed over the
core and rotated 1/3 turn (Shown in Figure 4 for
proper placement and Figure 5 for improper
placement).
NOTE: To have proper number of wafers it may
be necessary to tap them with a heavy rubber
hammer.
NOTE: For 1/2 wire and 1/2 poly place a poly wafer
on each end.
15. Reattach the end cap.
16. Place broom core into broom head.
17. Reattach the motor assembly.
18. Check for proper operation.
A
