8 Operating Problems
TC29
82
Fault Possible
cause
Remedy
8.5 Excavator installation is not working
1
Exit barrier lifted or shutoff valve damaged Lower exit barrier and/or check shutoff valve or
replace or repair if necessary.
2
Oil supply to hydraulic pump interrupted
Check pipes.
3
Hydraulic pump has failed
Have hydraulic pump checked by a specialist
and replace, if necessary
4
Main pressure relief valves have failed or
are mis-adjusted
Check main pressure relief valve and replace, if
necessary
8.6 Decrease in machine’s performance
1
Insufficient engine power
Check diesel engine.
2
Hydraulic oil level too low
Top up hydraulic oil to the mark
3
Pump is sucking up air
Tighten hose connections. Replace O-ring or
seals
4
Insufficient operating pressure
Re-adjust or replace main pressure relief valves
8.7 Machine is working too slowly and hydraulic oil is becoming too hot
1
Incorrect adjustment of main pressure
relief valves, damaged valves
Re-adjust main pressure relief valves or replace
if necessary
2
Hydraulic pump worn
Replace hydraulic pump
3
Incorrect hydraulic oil
Quality of hydraulic oil must conform to our
recommendation
4
Oil level too low
Top up oil to the mark on the sight glass
5
Oil cooler dirty or damaged
Clean, check and replace if necessary
6
Air in hydraulic system
Tighten connections with engine off and system
relieved of pressure
8.8 Uppercarriage is slewing too far
1
Secondary valves damaged or mis-
adjusted
Re-adjust secondary valves and replace if
necessary
2
Swing motor is leaking - internal wear
Replace hydraulic motor
Summary of Contents for TC29
